Welding Parameters For Mig/Mag Standard Synergic Welding - Fronius TPS 320i Operating Instructions Manual

Welding parame- The following welding parameters for MIG/MAG standard synergic welding can be set and
ters for MIG/MAG displayed by selecting the "Welding" menu button:
standard syner-
gic welding
Current recomm value
Unit
Setting range
Before the start of welding, the device automatically displays a standard value based on
the programmed parameters. During welding, the actual value is displayed.
Voltage recomm value
Unit
Setting range
Before the start of welding, the device automatically displays a standard value based on
the programmed parameters. During welding, the actual value is displayed.
Material command value
Unit
Setting range
Feeder command value
for setting a harder, more stable arc
Unit
Setting range
Arc length correction
for correcting the arc length
Setting range
Factory setting
-
0
+
Pulse/dynamic correction
for influencing the short-circuiting dynamic at the moment of droplet transfer
Setting range
Factory setting
-
0
+
Explanation of 1)
footnotes
66
1)
A
depends on the welding process and welding program selected
1)
V
depends on the welding process and welding program selected
1)
mm
0.1 - 30.0 mm
1)
m/min
0.5 - max.
-10 - +10
0
shorter arc length
neutral arc length
longer arc length
-10 - +10
0
harder, more stable arc
neutral arc
soft, low-spatter arc
Synergic parameter
When a synergic parameter is changed, the synergic function automatically chang-
es all other synergic parameters to match.
in.
2)
0.004 - 1.18
ipm.
2)
19.69 - max
2)
2)