Mig/Mag Welding Parameters; Welding Parameters For Mig/Mag Pulse Synergic Welding And Pmc Welding - Fronius TPS 320i Operating Instructions Manual

MIG/MAG welding parameters

Welding parame- The following welding parameters for MIG/MAG pulse synergic welding and PMC welding
ters for MIG/MAG can be set and displayed by pressing the "Welding" button:
pulse synergic
welding and PMC
Current
welding
Unit
Setting range
Before the start of welding, the device automatically displays a standard value based on
the programmed parameters. During welding, the actual value is displayed.
Voltage
Unit
Setting range
Before the start of welding, the device automatically displays a standard value based on
the programmed parameters. During welding, the actual value is displayed.
Material thickness
Unit
Setting range
Feeder command value
Unit
Setting range
Arc length correction
For correcting the arc length;
Setting range
Factory setting
-
0
+
Pulse/dynamic correction
For correcting the pulsing energy of a pulsed arc
Setting range
Factory setting
-
0
+
1)
A
Depends on the welding process and welding program selected
1)
V
Depends on the welding process and welding program selected
1)
mm
0.1 - 30.0 mm
1)
m/min
0.5 - max.
-10 - +10
0
Shorter arc length
Neutral arc length
Longer arc length
-10 - +10
0
Lower droplet detachment force
Neutral droplet detachment force
Higher droplet detachment force
in.
2) 2)
0.004 - 1.18
ipm.
2) 3) 2) 3)
19.69 - max
69