Selecting The Filler Metal And Shielding Gas - Fronius TPS 320i Operating Instructions Manual

An overview of the operating modes is displayed:
-
-
-
-
5
Selecting the filler
metal and shield-
ing gas
1
2
3
4
5
6
7
8
9
10
11
12
13
14
The confirmation step of the filler metal wizard is displayed:
15
2-step mode
4-step mode
Special 2-step mode
Special 4-step mode
Select the desired operating mode
AlMg 5
1
Select "Welding process"
Select "Filler metal"
Select "change Materialsettings"
Turn the adjusting dial and select the desired filler metal
Select "Next" / press the adjusting dial
Turn the adjusting dial and select the desired wire diameter
Select "Next" / press the adjusting dial
Turn the adjusting dial and select the desired shielding gas
Select "Next" / press the adjusting dial
NOTE! The available characteristics per welding process are not displayed if only
one characteristic is available for the selected filler metal. In this case, the confir-
mation step of the filler metal wizard follows immediately; steps 10 - 14 do not ap-
ply.
Turn the adjusting dial and select the desired welding process
To select the desired characteristic, press the adjusting dial (blue background)
Turn the adjusting dial and select the desired characteristic
Press the adjusting dial and apply the selected characteristic (white background)
Select "Next"
Select "Save" / press the adjusting dial
3
2
71