Job Welding - Retrieving A Job - Fronius TPS 320i Operating Instructions Manual

6
7
The name is saved and a confirmation that the job has been stored is displayed.
8
Job welding - re-
trieving a job
1
2
3
Job mode is activated.
"Job welding" and the data from the most recently retrieved job are displayed.
4
5
6
7
8
9
IMPORTANT! "Job number" is the only parameter that can be altered in Job mode; all the
others are read-only.
Enter a job name
Select "OK" and confirm the job name / press the adjusting dial
To exit, select "Finish" / press the adjusting dial
NOTE! Before retrieving a job, make sure that the welding system has been in-
stalled and set up for the job.
1
Select "Welding process"
Select "Process"
Select "Job mode"
Select "Job welding"
Turn the adjusting dial and select "Job number" (white background)
To select the desired job, press the adjusting dial (blue background)
Turn the adjusting dial to select the desired job number (blue background)
The name of the selected job is displayed above the actual value display.
Press the adjusting dial and accept the selected job number (white background)
Start welding
2
3
81