Setting Correction Boundaries For A Job - Fronius TPS 320i Operating Instructions Manual

5
Setting correction Individual correction boundaries for welding power and arc length can be defined for each
boundaries for a job.
job If correction boundaries are defined for a job, the welding power and arc length for the job
in question can be corrected within the defined boundaries while welding.
1
2
An overview of the job functions is displayed.
86
The choice between the job and the job welding parameters can also be made by
touching the "Job number / Job parameter" button.
Select job:
- Press the adjusting dial
The job number is highlighted in blue and can now be changed.
- Turn the adjusting dial to select the job to be altered
- Press the adjusting dial to change the job
Select job welding parameters:
- Turn the adjusting dial and select the parameter to be changed
- Press the adjusting dial
The value of the welding parameter is highlighted in blue and can now be
changed.
- Turn the adjusting dial; the amended value is applied immediately
- Press the adjusting dial to select other welding parameters
Select "Finish"
1
Select "Process parameters"
Select "JOB"
2