Function (Operation / Inspection Mode) - Canon MF735C Series Service Manual

FEEDER (ADF service mode) > ADJUST (Adjustment mode)
LA-SPD2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Unit
Default Value

FUNCTION (Operation / inspection mode)

FEEDER (ADF service mode) > FUNCTION (Operation / inspection mode)
MTR-ON
Detail
Use Case
Adj/Set/Operate Method
Required Time
FEED-ON
Detail
Use Case
Adj/Set/Operate Method
Related Service Mode
FEED-CHK
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
Supplement/Memo
Fine adj img ratio:stream,vert scan,bck
To make a fine adjustment of the image magnification ratio in vertical scanning direction on the
back side at stream reading.
When replacing the Main Controller PCB/clearing RAM data, enter the value of service label.
As the value is incremented by 1, the image is reduced by 0.01% in vertical scanning direction.
(The feeding speed increases, and the image is reduced.)
The setting is applied to the image on the back side.
- When installing the DADF
- When replacing the Main Controller PCB/clearing RAM data
Enter the setting value (switch negative/positive by +/- key), and then press Apply key.
-200 to 200
0.01%
0
Operation check of ADF Motor
To start operation check of ADF Motor (M702).
At operation check
1) Select the item, and then press Yes key.
It is driven for approximately 5 seconds and is automatically stopped.
2) Press Yes key.
The operation check is completed.
5 seconds
Operation check of DADF individual feed
To start operation check of the feed mode specified by FEED-CHK.
At operation check
Select the item, and then press Yes key.
FEEDER> FUNCTION> FEED-CHK
Specify DADF individual feed operation
To specify the feed mode for DADF.
Feed operation is activated by FEED-ON.
At operation check
Enter the setting value, and then press Apply key.
0 to 1
0: 1-sided
1: 2-sided
0
FEEDER> FUNCTION> FEED-ON
In the case of DADF (1-path model), operation is the same when either value is set.
321
9. Service Mode