Canon MF735C Series Service Manual page 253

Hide thumbs Also See for MF735C Series:
Table of Contents

Advertisement

COPIER (Service mode for copier) > ADJUST (Adjustment mode) > ADJ-XY
ADJY-DF2
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Unit
Default Value
ADJ-X-MG
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Unit
Default Value
STRD-POS
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Unit
Default Value
Related Service Mode
Adj start pstn: stream, horz scan, back
To adjust the back side image reading start position in horizontal scanning direction at stream
reading.
When replacing the Main Controller PCB, enter the value of service label.
As the value is incremented by 1, the image position is moved to the rear side by 0.1 mm.
- When replacing the DADF
- When replacing the Scanner Unit
- When replacing the Main Controller PCB
Enter the setting value (switch negative/positive by +/- key), and then press Apply key.
After the setting value is changed, write the changed value in the service label.
-15 to 15
0.1 mm
0
Fine adj img ratio: book mode, vert scan
To make a fine adjustment of image magnification ratio in vertical scanning direction at copyboard
reading.
When replacing the Main Controller PCB/clearing RAM data, enter the value of service label.
As the value is changed by 1, the image magnification ratio is changed by 0.01 %.
+: Enlarge
-: Reduce
- When replacing the DADF
- When replacing the Scanner Unit
- When replacing the Main Controller PCB
Enter the setting value (switch negative/positive by +/- key), and then press Apply key.
After the setting value is changed, write the changed value in the service label.
-200 to 200
0.01%
0
Adj Scan Unit pstn: stream, fd way, frt
To adjust the position of the Scanner Unit on the Reader side in feed direction at stream reading.
When replacing the Main Controller PCB, enter the value of service label.
The setting is applied to only the image on the front side.
- When replacing the DADF
- When replacing the Scanner Unit
- When replacing the Main Controller PCB
Enter the setting value (switch negative/positive by +/- key), and then press Apply key.
After the setting value is changed, write the changed value in the service label.
-30 to 20
0.1 mm
0
COPIER> FUNCTION> INSTALL> STRD-POS
244
9. Service Mode

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents