Canon MF735C Series Service Manual page 291

COPIER (Service mode for copier) > ADJUST (Adjustment mode) > FEED-ADJ
ADJ-C2YR
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Unit
Default Value
ADJ-C2XR
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Unit
Default Value
■ PANEL
COPIER (Service mode for copier) > ADJUST (Adjustment mode) > PANEL
TOUCHCHK
Detail
Use Case
Adj/Set/Operate Method
Related Service Mode
TOUCH-R
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
Adjustment of write start position in feed direction at Cassette 2 pickup (1st side of 2-sided
print)
To adjust the write start position in the feed direction for the image on the 2nd side at the time of
pickup from the Cassette 2.
As the value is changed by 1, the leading edge margin is changed by 0.001 mm.
+: Leading edge margin becomes larger. (An image moves to the trailing edge side.)
-: Leading edge margin becomes smaller. (An image moves to the leading edge side.)
When replacing the Engine Controller PCB/clearing RAM data, enter the value of service label.
The setting is applied to the 1st side at 2-sided print.
When replacing the Engine Controller PCB/clearing RAM data
Enter the setting value (switch negative/positive by +/- key) and press Apply key.
-5080 to 5080
0.001 mm
0
Adjustment of write start position in horizontal scanning direction at Cassette 2 pickup (1st
side of 2-sided print)
To adjust the write start position in the horizontal scanning direction for the image on the 2nd side
at the time of pickup from the Cassette 2.
As the value is changed by 1, the left margin is changed by 0.001 mm.
+: Left margin becomes larger. (An image moves to the right.)
-: Left margin becomes smaller. (An image moves to the left.)
When replacing the Engine Controller PCB/clearing RAM data, enter the value of service label.
The setting is applied to the 1st side at 2-sided print.
When replacing the Engine Controller PCB/clearing RAM data
Enter the setting value (switch negative/positive by +/- key) and press Apply key.
-5080 to 5080
0.001 mm
0
Adj of coordinate pstn on Touch Panel
To adjust the coordinate position on the Touch Panel of the Control Panel.
By making adjustment, the setting of TOUCH-R becomes 1.
When replacing the LCD Panel
1) Select the item, and then press Yes key.
2) Press the nine "+" keys in sequence.
COPIER> ADJUST> PANEL> TOUCH-R
Touch Panel coordinate pstn adj result
To set whether adjustment of the coordinate position on the Touch Panel of the Control Panel is
completed.
When adjustment with TOUCHCHK is completed, the setting of this item becomes 1.
When replacing the LCD Panel
Enter the setting value, and then press Apply key.
0 to 1
0: Not completed
1: Completed
0
COPIER> ADJUST> PANEL> TOUCHCHK
282
9. Service Mode