Canon MF735C Series Service Manual page 286

COPIER (Service mode for copier) > ADJUST (Adjustment mode) > CCD
LNR-OF-R
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
LNR-OF-G
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
LNR-OF-B
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
■ PASCAL
COPIER (Service mode for copier) > ADJUST (Adjustment mode) > PASCAL
OFST-P-Y
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
OFST-P-M
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
Frt/bck linearity offset crrct coeff (R)
To adjust the red color offset correction coefficient of the front/back side linearity.
When replacing the Main Controller PCB/clearing RAM data
Enter the setting value, and then press Apply key.
-128 to 127
0
Frt/bck linearity offset crrct coeff (G)
To adjust the green color offset correction coefficient of the front/back side linearity.
When replacing the Main Controller PCB/clearing RAM data
Enter the setting value, and then press Apply key.
-128 to 127
0
Frt/bck linearity offset crrct coeff (B)
To adjust the blue color offset correction coefficient of the front/back side linearity.
When replacing the Main Controller PCB/clearing RAM data
Enter the setting value, and then press Apply key.
-128 to 127
0
Adj Y-color density at test print read
To adjust the offset of Y-color test print reading signal at auto gradation adjustment (full
adjustment).
When replacing the Main Controller PCB/clearing RAM data, enter the value of service label.
As the value is larger, the image after adjustment gets darker.
- When replacing the Reader Unit
- When replacing the Main Controller PCB/clearing RAM data
Enter the setting value (switch negative/positive by +/- key), and then press Apply key.
After the setting value is changed, write the changed value in the service label.
-128 to 128
0
Adj M-color density at test print read
To adjust the offset of M-color test print reading signal at auto gradation adjustment (full
adjustment).
When replacing the Main Controller PCB/clearing RAM data, enter the value of service label.
As the value is larger, the image after adjustment gets darker.
- When replacing the Reader Unit
- When replacing the Main Controller PCB/clearing RAM data
Enter the setting value (switch negative/positive by +/- key), and then press Apply key.
After the setting value is changed, write the changed value in the service label.
-128 to 128
0
277
9. Service Mode