Error Code; Error Code Details - Canon MF735C Series Service Manual

Error Code

Error Code Details

E000-0000---
Detection Description
Remedy
E001-0000---
Detection Description
Remedy
E001-0001---
Detection Description
Remedy
E003-0000---
Detection Description
Remedy
E003-0001---
Detection Description
Remedy
E004-0000---
Detection Description
Remedy
E012-0000---
Detection Description
Remedy
E012-0001---
Detection Description
Remedy
E014-0000---
Detection Description
Remedy
Error in temperature rising of Fixing Assembly
Temperature of the Fixing Assembly did not reach a certain temperature within the specified period
of time.
1. Check the connector connection between the Fixing Assembly and the Engine Controller PCB.
2. Replace the Fixing Assembly.
3. Replace the Engine Controller PCB.
Abnormal high temperature of Fixing Assembly
It was detected that the temperature of the Fixing Assembly was abnormally high.
1. Check the connector connection between the Fixing Assembly and the Engine Controller PCB.
2. Replace the Fixing Assembly.
3. Replace the Engine Controller PCB.
Abnormal high temperature of Fixing Assembly
It was detected that the temperature of the Fixing Assembly (Sub Thermistor) was abnormally high.
1. Check the connector connection between the Fixing Assembly and the Engine Controller PCB.
2. Replace the Fixing Assembly.
3. Replace the Engine Controller PCB.
Abnormal low temperature of Fixing Assembly
It was detected that the temperature of the Fixing Assembly was abnormally low.
1. Check the connector connection between the Fixing Assembly and the Engine Controller PCB.
2. Replace the Fixing Assembly.
3. Replace the Engine Controller PCB.
It was detected that the temperature of the Fixing Assembly (Sub Thermistor) was
abnormally low.
It was detected that the temperature of the Fixing Assembly (Sub Thermistor) was abnormally low.
1. Check the connector connection between the Fixing Assembly and the Engine Controller PCB.
2. Replace the Fixing Assembly.
3. Replace the Engine Controller PCB.
Error in fixing power supply drive circuit
The zero cross signal was not detected for the specified period of time
or more.
1. Check the connector connection between the Fixing Assembly and the Engine Controller PCB.
2. Replace the Fixing Assembly.
3. Replace the Engine Controller PCB.
Black Drum Motor error
An error in the initial operation of the Drum Motor was detected.
1. Reconnect the connector of the Main Motor.
2. Replace the Engine Controller PCB.
Black Drum Motor error
Rotation error of the Drum Motor was detected.
1. Reconnect the connector of the Main Motor.
2. Replace the Engine Controller PCB.
Error in startup of the Main Motor
Revolution of the Main Motor did not reach the specified value.
1. Check the connector connection between the Main Motor and the Engine Controller PCB.
2. Replace the Main Motor.
3. Replace the Engine Controller PCB.
225
8. Error/Jam/Alarm