Canon MF735C Series Service Manual page 305

■ SPLMAN
COPIER (Service mode for copier) > FUNCTION (Operation / inspection mode) > SPLMAN
SPL14159
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
SPL37510
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
SPL65677
Detail
Adj/Set/Operate Method
Display/Adj/Set Range
Unit
Default Value
Related Service Mode
SPL68676
Detail
Adj/Set/Operate Method
Display/Adj/Set Range
Unit
Default Value
Related Service Mode
ON/OFF of USB device ID fixing
To set whether to fix the USB device ID to "000000000000".
A PC attempts to install the driver every time it is connected to a machine. However, by fixing the
USB device ID, it recognizes that the same machine is connected so that it does not attempt to
install the driver again.
When saving the trouble of selecting a device used for printing from the candidate devices because
the driver is installed every time a USB is connected
1) Enter the setting value, and then press Apply key.
2) Turn OFF/ON the main power switch.
0 to 1
0: OFF, 1: ON
0
ON/OFF of ITB cleaning at paper size mismatch
Normally, when paper other than that of the specified size is fed, ITB cleaning is executed to
remove toner.
When 1 is set, ITB cleaning is not executed even if paper size is mismatched. Productivity
improves, but toner soiling may occur.
When paper size is mismatched
Enter the setting value, and then press Apply key.
Be sure to get approval from the user by telling that toner soiling may occur to improve productivity.
0 to 1
0: OFF
1: ON
0
Increase of paper leading edge margin
To increase the margin on the leading edge of paper.
As the value is incremented by 1, the margin is increased by 0.1 mm.
Actually, a value where the setting value of SPL68676 is subtracted from the setting value of this
item is applied.
The margin settings which are job-specific or based on the printable area are applied regardless
of the setting of this item.
1) Enter the setting value, and then press Apply key.
2) Turn OFF/ON the main power switch.
0 to 20
0.1 mm
0
COPIER> FUNCTION> SPLMAN> SPL68676
Decrease of paper leading edge margin
To decrease the margin on the leading edge of paper.
As the value is incremented by 1, the margin is decreased by 0.1 mm.
Actually, a value where the setting value of this item is subtracted from the setting value of
SPL65677 is applied.
The margin settings which are job-specific or based on the printable area are applied regardless
of the setting of this item.
1) Enter the setting value, and then press Apply key.
2) Turn OFF/ON the main power switch.
0 to 20
0.1 mm
0
COPIER> FUNCTION> SPLMAN> SPL65677
296
9. Service Mode