Canon MF735C Series Service Manual page 300

COPIER (Service mode for copier) > FUNCTION (Operation / inspection mode) > CLEAR
ERDS-DAT
Detail
Use Case
Adj/Set/Operate Method
Caution
Related Service Mode
Supplement/Memo
PLPW-CLR
Detail
Use Case
Adj/Set/Operate Method
■ MISC-R
COPIER (Service mode for copier) > FUNCTION (Operation / inspection mode) > MISC-R
SCANLAMP
Detail
Use Case
Adj/Set/Operate Method
SCAN-ON
Detail
Adj/Set/Operate Method
SCANLMP2
Detail
Use Case
Adj/Set/Operate Method
1PSCLB-A
Detail
Use Case
Adj/Set/Operate Method
Caution
Related Service Mode
Supplement/Memo
Initialize of Embedded-RDS setting value
To initialize the Embedded-RDS setting values.
ON/OFF of Embedded-RDS, UGW port number and communication error log set in ERDS, RGW-
PORT, and COM-LOG are cleared.
When upgrading the Bootable in the Embedded-RDS environment
Select the item, and then press Yes key.
Use of the SRAM in Embedded-RDS differs depending on the Bootable version. Therefore, unless
initialization is executed at the time of version upgrade, data inconsistency occurs.
COPIER> FUNCTION> INSTALL> ERDS, RGW-PORT, COM-LOG
Embedded-RDS: Function to send device information such as the device counter, failure, and
consumables to UGW via SOAP protocol
UGW (Universal Gate Way): Remote monitoring service system
Clear security policy setting password
To clear the password of the security administrator set in the security policy settings.
When clearing the password of the security administrator
Select the item, and then press Yes key.
Lighting check of CIS Unit LED: front
To light up the Scanning LED of the Scanner Unit (for front side).
When replacing the CIS Unit LED
Select the item, and then press Yes key.
Execution of copyboard reading operation
To execute reading of the original on the Copyboard Glass.
1) Place paper on the Copyboard Glass.
2) Select the item, and then press Yes key.
Lighting check of CIS Unit LED: back
To light up the Scanning LED of the Scanner Unit (for back side).
When replacing the CIS Unit LED
Select the item, and then press Yes key.
Exe frt/bck clr differ calibration: frt
To read the PG for calibrating color difference between the front and back sides with the Scanner
Unit (for front side) in order to correct the color difference between the front and back sides at
duplex stream reading.
A significant color difference may occur between the images on the front and back sides scanned
with the DADF caused by variations in the LED and changes in durability. Such a color difference
is corrected by executing 1PSCLB-B following 1PSCLB-A.
When a significant color difference occurs between the front and back side at DADF duplex reading
1) Place the paper on which PG is printed on the DADF.
2) Select the item, and then press OK key.
- Do not turn OFF/ON the main power switch during execution of 1PSCLB-A and then 1PSCLB-
B.
- Until 1 is displayed in both 1P-ERR-A and 1P-ERR-B, calibration of color difference between the
front and back sides is not completed.
COPIER> FUNCTION> MISC-R> 1PSCLB-B
COPIER> DISPLAY> CCD> 1P-ERR-A/B
The execution result of this item is displayed in 1P-ERR-A.
291
9. Service Mode