Canon MF735C Series Service Manual page 288

COPIER (Service mode for copier) > ADJUST (Adjustment mode) > FEED-ADJ
ADJ-MFX
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Unit
Default Value
ADJ-MFYR
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Unit
Default Value
ADJ-MFXR
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Unit
Default Value
Adjustment of write start position in horizontal scanning direction at Multi-purpose Tray
pickup (1-sided print/2nd side of 2-sided print)
To adjust the write start position in the horizontal scanning direction for the image on the 1st side
at the time of pickup from the Multi-purpose Tray.
As the value is changed by 1, the left margin is changed by 0.001 mm.
+: Left margin becomes larger. (An image moves to the right.)
-: Left margin becomes smaller. (An image moves to the left.)
When replacing the Engine Controller PCB/clearing RAM data, enter the value of service label.
The setting is applied to the 1st side at 1-sided print and the 2nd side at 2-sided print.
When replacing the Engine Controller PCB/clearing RAM data
Enter the setting value (switch negative/positive by +/- key) and press Apply key.
-5080 to 5080
0.001 mm
0
Adjustment of write start position in feed direction at Multi-purpose Tray pickup (1st side
of 2-sided print)
To adjust the write start position in the feed direction for the image on the 2nd side at the time of
pickup from the Multi-purpose Tray.
As the value is changed by 1, the leading edge margin is changed by 0.001 mm.
+: Leading edge margin becomes larger. (An image moves to the trailing edge side.)
-: Leading edge margin becomes smaller. (An image moves to the leading edge side.)
When replacing the Engine Controller PCB/clearing RAM data, enter the value of service label.
The setting is applied to the 1st side at 2-sided print.
When replacing the Engine Controller PCB/clearing RAM data
Enter the setting value (switch negative/positive by +/- key) and press Apply key.
-5080 to 5080
0.001 mm
0
Adjustment of write start position in horizontal scanning direction at Multi-purpose Tray
pickup (1st side of 2-sided print)
To adjust the write start position in the horizontal scanning direction for the image on the 2nd side
at the time of pickup from the Multi-purpose Tray.
As the value is changed by 1, the left margin is changed by 0.001 mm.
+: Left margin becomes larger. (An image moves to the right.)
-: Left margin becomes smaller. (An image moves to the left.)
When replacing the Engine Controller PCB/clearing RAM data, enter the value of service label.
The setting is applied to the 1st side at 2-sided print.
When replacing the Engine Controller PCB/clearing RAM data.
Enter the setting value (switch negative/positive by +/- key) and press Apply key.
-5080 to 5080
0.001 mm
0
279
9. Service Mode