Canon MF735C Series Service Manual page 258

COPIER (Service mode for copier) > ADJUST (Adjustment mode) > CCD
50-RG
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Unit
Default Value
Supplement/Memo
50-GB
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Unit
Default Value
Supplement/Memo
100-RG
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Unit
Default Value
Supplement/Memo
100-GB
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Unit
Default Value
Supplement/Memo
RG clr displace correct: 50% book mode
To correct the color displacement between R and G lines in vertical scanning direction that occurs
at 50% copyboard reading.
When replacing the Main Controller PCB/clearing RAM data, enter the value of service label.
When replacing the Main Controller PCB/clearing RAM data
Enter the setting value (switch negative/positive by +/- key), and then press Apply key.
After the setting value is changed, write the changed value in the service label.
-512 to 512
0.001 line
-333
50% reading: 300 dpi in horizontal scanning direction x 600 dpi in vertical scanning direction
GB clr displace correct: 50% book mode
To correct the color displacement between G and B lines in vertical scanning direction that occurs
at 50% copyboard reading.
When replacing the Main Controller PCB/clearing RAM data, enter the value of service label.
When replacing the Main Controller PCB/clearing RAM data
Enter the setting value (switch negative/positive by +/- key), and then press Apply key.
After the setting value is changed, write the changed value in the service label.
-512 to 512
0.001 line
333
50% reading: 300 dpi in horizontal scanning direction x 600 dpi in vertical scanning direction
RG clr displace correct: 100% book mode
To correct the color displacement between R and G lines in vertical scanning direction that occurs
at 100% copyboard reading.
When replacing the Main Controller PCB/clearing RAM data, enter the value of service label.
When replacing the Main Controller PCB/clearing RAM data
Enter the setting value (switch negative/positive by +/- key), and then press Apply key.
After the setting value is changed, write the changed value in the service label.
-512 to 512
0.001 line
-333
100 reading: 600 dpi in horizontal scanning direction x 600 dpi in vertical scanning direction
GB clr displace correct: 100% book mode
To correct the color displacement between G and B lines in vertical scanning direction that occurs
at 100% copyboard reading.
When replacing the Main Controller PCB/clearing RAM data, enter the value of service label.
When replacing the Main Controller PCB/clearing RAM data
Enter the setting value (switch negative/positive by +/- key), and then press Apply key.
After the setting value is changed, write the changed value in the service label.
-512 to 512
0.001 line
333
100 reading: 600 dpi in horizontal scanning direction x 600 dpi in vertical scanning direction
249
9. Service Mode