Canon MF735C Series Service Manual page 262

COPIER (Service mode for copier) > ADJUST (Adjustment mode) > CCD
MTF2-M5
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
MTF2-M6
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
MTF2-M7
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
MTF2-M8
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
MTF value 5 entry:DADF, front, horz scan
To enter the setting value for calculating MTF filter coefficient in horizontal scanning direction on
the front side at DADF stream reading.
When replacing the Main Controller PCB/clearing the Reader-related RAM data, enter the value
of the service label on the reader.
When replacing the Scanner Unit (for front side), enter the value of service label on a new unit.
- When replacing the Main Controller PCB/clearing the Reader-related RAM data
- When replacing the Scanner Unit (for front side)
Enter the setting value, and then press Apply key.
0 to 100
100
MTF value 6 entry:DADF, front, horz scan
To enter the setting value for calculating MTF filter coefficient in horizontal scanning direction on
the front side at DADF stream reading.
When replacing the Main Controller PCB/clearing the Reader-related RAM data, enter the value
of the service label on the reader.
When replacing the Scanner Unit (for front side), enter the value of service label on a new unit.
- When replacing the Main Controller PCB/clearing the Reader-related RAM data
- When replacing the Scanner Unit (for front side)
Enter the setting value, and then press Apply key.
0 to 100
100
MTF value 7 entry:DADF, front, horz scan
To enter the setting value for calculating MTF filter coefficient in horizontal scanning direction on
the front side at DADF stream reading.
When replacing the Main Controller PCB/clearing the Reader-related RAM data, enter the value
of the service label on the reader.
When replacing the Scanner Unit (for front side), enter the value of service label on a new unit.
- When replacing the Main Controller PCB/clearing the Reader-related RAM data
- When replacing the Scanner Unit (for front side)
Enter the setting value, and then press Apply key.
0 to 100
100
MTF value 8 entry:DADF, front, horz scan
To enter the setting value for calculating MTF filter coefficient in horizontal scanning direction on
the front side at DADF stream reading.
When replacing the Main Controller PCB/clearing the Reader-related RAM data, enter the value
of the service label on the reader.
When replacing the Scanner Unit (for front side), enter the value of service label on a new unit.
- When replacing the Main Controller PCB/clearing the Reader-related RAM data
- When replacing the Scanner Unit (for front side)
Enter the setting value, and then press Apply key.
0 to 100
100
253
9. Service Mode