Canon MF735C Series Service Manual page 255

COPIER (Service mode for copier) > ADJUST (Adjustment mode) > CCD
W-PLT-Z
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
Related Service Mode
DFTAR-R
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
DFTAR-G
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
Stdrd White Plt white lvl data (Z) entry
To enter the white level data (Z) for the Standard White Plate.
When replacing the DADF/Reader Unit, Reader Upper Cover Unit or Main Controller PCB, enter
"ZZZZ" of the value (XXXXYYYYZZZZ) shown on the barcode label affixed at the upper left of the
Copyboard Glass.
- When replacing the DADF/Reader Unit
- When replacing the Reader Upper Cover Unit
- When replacing the Main Controller PCB
Enter the setting value, and then press Apply key.
After the setting value is changed, write the changed value in the service label.
7000 to 9999
9427
COPIER.> ADJUST> CCD> W-PLT-X/Y
Shading target VL (R) entry: front side
To enter the shading target value of Red of the Scanner Unit (for front side) at stream reading.
When replacing the Main Controller PCB/clearing RAM data, enter the value of service label.
When replacing the DADF/Reader Unit, Scanner Unit, or Reader Upper Cover Unit, execute DF-
WLVL1 and DF-WLVL2 and write the value which is automatically set in the service label.
The setting is applied to only the image on the front side.
- When replacing the Main Controller PCB/clearing RAM data
- When replacing the DADF/Reader Unit
- When replacing the Scanner Unit
- When replacing the Reader Upper Cover Unit
Enter the setting value, and then press Apply key.
0 to 2048
1105
COPIER> DISPLAY> CCD> TARGET-R
COPIER> FUNCTION> CCD> DF-WLVL1/2
Shading target VL (G) entry: front side
To enter the shading target value of Green of the Scanner Unit (for front side) at stream reading.
When replacing the Main Controller PCB/clearing RAM data, enter the value of service label.
When replacing the DADF/Reader Unit, Scanner Unit, or Reader Upper Cover Unit, execute DF-
WLVL1 and DF-WLVL2 and write the value which is automatically set in the service label.
The setting is applied to only the image on the front side.
- When replacing the Main Controller PCB/clearing RAM data
- When replacing the DADF/Reader Unit
- When replacing the Scanner Unit
- When replacing the Reader Upper Cover Unit
Enter the setting value, and then press Apply key.
0 to 2048
1129
COPIER> DISPLAY> CCD> TARGET-G
COPIER> FUNCTION> CCD> DF-WLVL1/2
246
9. Service Mode