Enabling Snmp Notifications For Pim; Enabling Nbma Mode For Advpn Tunnel Interfaces - HP MSR1002-4 Configuration Manual

immediately takes over when the active process fails. Use this feature to avoid route flapping and
forwarding interruption for PIM when an active/standby switchover occurs.
To enable PIM NSR:
Step
1. Enter system view.
2. Enable PIM NSR.

Enabling SNMP notifications for PIM

To report critical PIM events to an NMS, enable SNMP notifications for PIM. For PIM event
notifications to be sent correctly, you must also configure SNMP as described in Network
Management and Monitoring Configuration Guide.
To enable SNMP notifications for PIM:
Step
1. Enter system view.
2. Enable SNMP notifications
for PIM.

Enabling NBMA mode for ADVPN tunnel interfaces

This feature allows ADVPN tunnel interfaces to forward multicast data to target spokes and hubs.
For more information about ADVPN, see Layer 3
Configuration restrictions and guidelines
When you enable NBMA mode, follow these restrictions and guidelines:
•
This feature is not available for PIM-DM.
•
This feature takes effect only when PIM-SM is enabled on the ADVPN tunnel interface.
•
In a BIDIR-PIM domain, make sure RPs do not reside on ADVPN tunnel interfaces or on the
subnet where ADVPN tunnel interfaces are located.
•
Do not configure IGMP features on ADVPN tunnel interfaces that are enabled with NBMA
mode.
Configuration procedure
To enable NBMA mode for an ADVPN tunnel interface:
Step
1. Enter system view.
2. Enter interface view.
3. Enable NBMA mode.
Command
system-view
pim non-stop-routing
Command
system-view
snmp-agent trap enable pim
[ candidate-bsr-win-election |
elected-bsr-lost-election
neighbor-loss ] *
—
IP Services Configuration Guide.
Command
system-view
interface interface-type
interface-number
pim nbma-mode
124
Remarks
N/A
By default, PIM NSR is disabled.
Remarks
N/A
By default, SNMP notifications for
| PIM are enabled.
Remarks
N/A
N/A
By default, NBMA
disabled.
This command is applicable only
to ADVPN tunnel interfaces.
mode is