Canopen Setting (Starting Canopen Configuration Tool) - Mitsubishi Electric MELSEC iQ-R Series User Manual

2.4
CANopen Setting (Starting CANopen
Configuration Tool)
Start CANopen Configuration Tool to configure CANopen.
For details, refer to the following.
Page 79 CANopen Configuration Tool
• CANopen Configuration Tool can operate standalone even if GX Works3 terminates. The user can still
operate the configuration tool.
• CANopen Configuration Tool cannot be used in either 11-bit CAN-ID Layer 2 message mode or 29-bit CAN-
ID Layer 2 message mode.
Parameters set with CANopen Configuration Tool
Parameters set with CANopen Configuration Tool saved into a CPU module or SD memory card can be displayed in GX
Works3 as the module extension parameters.
For details on the storage of parameters set with CANopen Configuration Tool, refer to the following.
Page 112 Writing the settings
Module extension parameters cannot be read or edited using such a tool as GX Works3. To read parameters
for the RJ71CN91 from a CPU module or SD memory card using such a tool as GX Works3, exclude module
extension parameters from the targets.

2.4 CANopen Setting (Starting CANopen Configuration Tool)

2 PARAMETER SETTINGS
2
77