Parameter settings
Connect the engineering tool to the CPU module and set parameters.
Module parameter setting
1.
Set the CPU module as follows.
[Project] [New]
2.
Click the [OK] button to add the CPU module label.
3.
Add a general-purpose intelligent module (for single slot). (Set "Number of Occupied Points per 1 Slot" to "32 Points".)
[Navigation window] [Parameter] [Module Information] Right-click [Add New Module]
4.
Write the set parameters to the CPU module, and reset the CPU module or power off and on the system.
[Online] [Write to PLC]
In the program example, default settings are used for parameters other than the above. For details on
parameters, refer to the following.
Page 73 PARAMETER SETTINGS
4.1 Communication Example of Layer 2 Message Mode
4 PROGRAMMING
121
4