Dhcp-Snooping Global - TP-Link JetStream TL-SL5428E Cli Reference Manual

Command Mode
Global Configuration Mode
Example
Enable the DHCP-snooping function globally:
TP-LINK(config)# dhcp-snooping

dhcp-snooping global

Description
The dhcp-snooping global command is used to configure the DHCP snooping
globally. To restore to the default value, please use no dhcp-snooping global
command.
Syntax
dhcp-snooping global [global-rate{global-rate}] [dec-threshold{dec-threshold}]
[dec-rate{dec-rate}]
no dhcp-snooping global
Parameter
global-rate —— The value to specify the maximum amount of DHCP messages
that can be forwarded by the switch per second. The excessive massages will
be discarded. The options are 0/10/20/30/40/50 (packet/second).By default, it is
0 standing for disable.
dec-threshold ——The value to specify the minimum transmission rate of the
Decline packets to trigger the Decline protection for the specific port. The
options are 0/5/10/15/20/25/30 (packet/second).By default, it is 0 standing for
disable.
Dec-rate ——The value to specify the Decline Flow Control. The traffic flow of
the corresponding port will be limited to be this value if the transmission rate of
the Decline packets exceeds the Decline Threshold. The options are
5/10/15/20/25/30 (packet/second). By default, it is 5.
Command Mode
Global Configuration Mode
Example
Configure the Global Flow Control as 30pps, the Decline Threshold as 20 pps,
TL-SL5428E JetStream L2 Managed Switch CLI Guide
64