Ignitor Assembly - Henny Penny PFG-691 Technical Manual

2-30. IGNITOR ASSEMBLY

Replacement
Sept. 2004
The Model 691's electronic spark ignition, lights a standing pilot.
1. Remove electrical power supplied to the unit.
To avoid electrical shock or property damage, move the
power switch to OFF and disconnect main circuit
breaker, or unplug cord at wall receptacle.
TO AVOID INJURY, PROPERTY DAMAGE, OR
EXPLOSION, BEFORE REPLACING IGNITOR
ASSEMBLY, DO THE FOLLOWING:
• MOVE THE POWER/PUMP SWITCH TO THE
OFF POSITION.
• DISCONNECT THE MAIN CIRCUIT BREAKER
AT THE WALL, OR UNPLUG THE POWER CORD.
• TURN OFF THE MAIN GAS SUPPLY TO THE
FRYER AND DISCONNECT AND CAP THE
SUPPLY LINE TO FRYER.
2. Remove the control panel as discussed in the Complete
Control Panel-Henny Penny Section.
3. Disconnect the 1/4" gas line fitting from the pilot assembly.
4. Follow the wire from the spark ignitor to the module, and
remove the wire from the module.
5. Remove the left or right side panel, depending upon which
ignitor assembly will be removed.
6. Disconnect gas line (for the left ignitor assembly).
7. Remove the four screws securing the burner assembly, and
pull the assembly from the unit.
8. Using a Phillips head screwdriver, remove the screw securing
ignitor assembly to the burner assembly, and pull the ignitor
assembly from the unit.
9. Secure new assembly with screw previously removed, making
sure assembly is turned to provide a 1/8" (3.18 mm) gap
between the spark ignitor and the hood of pilot assembly.
2-30
Model 691