Henny Penny PFG-691 Technical Manual page 131

5 – 19 Adjusting the Magnet Plate
With the carrier and racks installed on the lid, the
lid should stay down, in contact with the pot rim,
when the lid is lowered. The user will then be
able to lock the lid in place. If the lid has a
tendency to rise up before getting the lid locked
down, the magnet plate probably needs
adjusting. Follow these steps:
1. Remove the six nuts securing the back
shroud and remove back shroud.
2. Loosen the bottom nut under the plate
and unscrew both nuts a couple turns,
then lower the lid again to see if the lid
stays down. If not, repeat procedure.
3. Tighten lower nut up against the other
nut and install back shroud – adjustment
is now complete.
Inspection 6
Rev. A