Henny Penny PFG-691 Technical Manual page 181

2-10. REVERSING THE LID GASKET The gray rubber gasket surrounding the inside
of the lid is designed to be reversed.
Because of heat expansion and the pressure
used for the cooking process, the gasket is
constantly under extreme stress. Reversing
the lid gasket will help to ensure that the fryer
will not lose pressure through leakage.
1. Put the lid in the upright position, as
previously described.
2. Using a thin blade screwdriver, pry
out the gasket at the corners. Remove
the gasket.
Check the gasket for any tears or nicks. If the
gasket is damaged, it needs to be replaced.
Be sure the metal arm on the left side of the
lid is in the vertical position holding the lid
upright, or severe injuries could result.
(See photo on page 2-7.)
3. Clean the gasket and gasket seat with
hot water. Rotate
4.
Rotate the gasket with the opposite
side facing out.
Install the four corners of the lid gasket.
Smooth the gasket into place, working from
the corners towards the middle of each side.
Inspection 37
Rev. A