Section 4. Programming - Henny Penny PFG-691 Technical Manual

Programming information is provided in this section. Operator menus are described in the Operator's
manual and are not included in this manual. All menus that pertain to maintenance are described in this
section.
To enter the menus perform the following steps:
1. Press and hold the PROGRAM button for five seconds.
2. Release the PROGRAM button as soon as "LEVEL 2" shows in the display.
3. Press the PROGRAM button until TECH is displayed (you are in tech mode now).
4. Enter the access code 11221122.
The only menu used for maintnenace for the Computron 8000 control is tech mode.
Menu Step
T-1 SOFTWARE ID'S
T-2 FRYER TYPE
T-3 PUSH-BUTTON TEST
T-4 ALL-ON DISPLAY TEST
T-5 SEGMENTS TEST
T-6 DIGITS TEST
Dec. 2016

SECTION 4. PROGRAMMING

View Software ID's
Press and hold [1]: HP P/N = 32609J (HP part number for the software)
Press and hold [2]: ID = HP C8000 (The specific customer or model number, etc.)
Press and hold [3]: SRL = 1.50 (Software Release Level (version) for this software)
Fryer type: Pressure Fryer or Open Fryer; Electric; 8-Head.
Auto-detected by the controller, based on I/O board and wiring harness connections.
(This is not a setting you can adjust.)
Auto-detection can complete only if the fryer is turned ON and the high-limit and drain
switch interlocks are closed. If the display indicates "NEED VHDS", then one of the
interlocks is not satisfied and the auto-detect routine is unable to proceed.
Pushbutton test mode.
Press and release buttons (starting with any button other than INFO or PROG) to activate
test mode. Main display shows an indicator letter for each button that is pressed:
Number buttons 1-0, Info, Down, Up, Prog, Left-side (Idle), Right-side (Timer)
Press and hold any number button to cause all display digit segments, decimal points,
LED's, and light bars to be lighted. Release button to return to normal mode.
Tests each individual display segment (all digits simultaneously) in order to assess
whether any segments might be bridged together.
Press and release any number button to step through the test sequence manually, or press
and release the Timer button to run the test sequence automatically one time through.
Tests each individual display digit (all segments on, one digit at a time) in order to assess
whether any solder bridges between digits exist.
Press and release any number button to step through the test sequence manually, or press
and release the Timer button to run the test sequence automatically one time through.
4-1
Description
Model 691