Power/Pump Switch - Henny Penny PFG-691 Technical Manual

2-5. POWER/PUMP SWITCH

Checkout
Replacement
Oct. 2004
The POWER/PUMP switch is a three-way rocker switch with a
center OFF position. With the switch in the POWER position,
the fryer will operate. With the switch in the PUMP position,
the filter pump will operate, but the unit will not heat.
To avoid electrical shock or property damage, move the
power switch to OFF and disconnect main circuit
breaker, or unplug cord at wall receptacle.
1. Remove control panel.
2. Label and remove wires from the switch.
3. "OFF" position - should be open circuit anywhere on the
switch.
4. "POWER" position
Check from:
5. "PUMP" position
Check from:
Check across the jumpers on the wires of the POWER/
PUMP switch. These jumpers have resistors and capacitors
which may be faulty.
1. With control panel removed, and wires off of the switch,
push in on tabs on the switch to remove from the panel.
2. Replace with new switch, and reconnect wires to switch
following the wiring diagram.
3. Replace the control panel.
2-4
#5 to #6 closed circuit
#l to #2 closed circuit
#4 to #5 closed circuit
#3 to #2 closed circuit
Model 691