Henny Penny PFG-691 Technical Manual page 180

2-12. PRESSURE PAD The pressure pads are plastic strips that the lid cam presses
against to seal the lid.
1. Raise the lid.
2. Remove the four screws securing the lid cover and remove
cover.
3. Push the lid cam back, off the pressure pads.
4. Using an Allen wrench, remove the large bolt securing pad.
5. Using a Phillips head screw driver, remove the small screw
securing the pad and remove the broken pad.
If the pressure pad is worn, but not broken, it can be
reversed 180 degrees, and the other end of the pad used.
6. Install new pad in reverse order.
Inspection 36
Rev A