Related Manuals for Henny Penny PFE-500
Summary of Contents for Henny Penny PFE-500
- Page 1 PFE-500 Electric Pressure Fryer(with pump) Electric Pressure Fryer INSTRUCTION MANUAL Read this manual carefully prior to use. Technology is subject to change without notice.
-
Page 2: Installation And Debugging
Character and usage The series of PFE-500 American style pressure fryer that my plant produced absorb the advanced technique from aboard and learn the production process of western chicken frying and traditional Chinese style chicken frying. . It has the characteristics of stainless steel material, use the electronics to adjust time, control temperature and expel the air automatically;... - Page 3 2. The grounding terminal of the machine shall be grounded reliably, its section ≥2.5 .If many machine is working at the same time, a equipotential device should be equipped between each set. 3. During the conveyance of the machine, the vibration will cause the loose or removal of the spare parts, so when installation and debugging, please tighten each loosening parts.
- Page 4 not close the lid. You can use the basket handle to mix the oil inside to make sure the temperature is even. After preheating, (means up to the setting temperature), turn off the machine, now you can put the prepared food into the basket( the machine is equipped with one basket), using the handle of the basket to lift the basket to the fry pot, then take the handle of the basket away and closed the fryer lid, make the pothook ok, then tighten the threaded rod.
- Page 5 will be a danger. When opening the cover, the operator should be stand side face, in case the hot air shall emit to scald his wrist. The operator must have a good knowledge of how to operate the machine to ensure the security.
-
Page 6: Troubleshooting
to keep clean and sanitary and enhance the use life span of the machine. After a relatively long time use, the rubber gasket shall be replaced in time if it is found aging and ineffective. Loosen the glue bar fastening screws of four sides on the cover, take out the glue bar fasten the screws.