Pressure Pads - Henny Penny PFG-691 Technical Manual

2-13. PRESSURE PADS

Sept. 2004
The pressure pads are plastic strips that the lid cam presses
against to seal the lid. They are located on top of the shims.
1. Raise the lid.
2. Remove the four screws securing the lid cover and remove
cover.
3. Push the lid cam back, off the pressure pads.
4. Using an Allen wrench, remove large bolt securing the pad.
5. Using a Phillips head screwdriver, remove the small screw
securing the pad securing the pressure plate and remove the
broken pad.
If the pressure pad is worn, but not broken, it can be
reversed 180 degrees, and the other end of the pad used.
6. Install new pad in reverse order.
2-11
Model 691