Level 1 Programming; Modifying Product Settings - Henny Penny GVE-071 Operator's Manual

SECTION 4: LEVEL 1 PROGRAMMING
4-1
MODIFYING
PRODUCT SETTINGS
July 2014
Level 1 contains the following:
•
Modify product settings
•
AIF clock (Blocks "FILTER NOW" prompts)
•
Perform the Deep Clean procedure
•
Fryer Setup Mode
1.
Press and hold and
display, followed by ENTER CODE.
2.
Enter code 1, 2, 3, 4 (first 4 product buttons). "PRODUCT" and
"SELECTN" show in the displays.
3.
Press right button and 'SELECT PRODUCT' and "-P 1-" (ex:
√
NUGGETS) show in the displays.
Change Product Names
4.
Use the ◄ and ► buttons to scroll through the 40 products, or
press the desired product button
5.
Press right button and the product (ex: NUGGETS) shows in the
√
left display and "MODIFY", and "YES NO" shows in the right
display. Press the button to change this product, or press the X
√
button to choose another product.
6.
If button was pressed, press and release a product button and the
√
flashing letter changes to the first letter under the product button
that was pressed. For example, if
changes to an "A".
Press the same button again and the flashing letter changes to a "B".
Press it again and the flashing letter changes to a "C". Once the
desired letter shows in the display, press ► button to continue to
the next letter and repeat the procedure.
Press and hold the right X button to exit Program Mode, or
press ▼ button to continue on to "1. COOK TIME".
To Change Times and Temperatures
7.
Press ▼ button until "COOK TIME" shows in the display, and then
use the product buttons
time in minutes and seconds, to a maximum of 59:59.
30
buttons until LEVEL - 1 shows in the
is pressed, the flashing letter
to change the
.