Hdmi Output - Promax HD RANGER 2 User Manual

The configuration window shows the options that user can modify:
number of slots, slot selected, device address, pilot signal activation
(when activating the SatCR device located in the headend, it emits a
pilot signal with constant level for each downlink frequency to
identificate available channels), selected satellite and frequency step.
In other box appears the frequencies corresponding to each slot.
10.5

HDMI Output

HDMI (High-Definition Multimedia Interface) is a compact audio/video interface
for transmitting uncompressed digital data. HDMI supports, on a single cable,
any TV or PC video format, including standard, enhanced, and high-definition
video; up to 8 channels of digital audio; and a Consumer Electronics Control
(CEC) connection. The CEC allows HDMI devices to control each other when
necessary and allows the user to operate multiple devices with one remote
control handset.
This connection allows the equipment to interface with other High Definition
equipment. It can also be very useful to check proper operation of the client's TV
while on a service call. Everything that can be seen on the meter's screen is
available through the HDMI.
To switch between the image from the equipment to an auxiliary monitor by
following these steps:
Connect the HDMI cable to the HDMI output connector (see figure 5),
ensuring that the plug is fully inserted.
Connect the opposite end to the auxiliary monitor where video and
audio of the equipment will be played.
10-124
Figure 75. SatCR command screen.
3
June 2014