Promax HD RANGER 2 User Manual page 110

Press on the "Datalogger" option.
It displays a menu with the "New ..." option and a list of all
dataloggers at the selected installation.
Select "New ..." to create a new datalogger or select the file name of
an existing datalogger if the user want to save data on a specific
datalogger already existing.
If "New ..." is selected, a installation wizard shows how to create a
new datalogger. Follow its instructions (
screen,
cancel).
During the creation of a new datalogger using the wizard, the user can
assign a name and select the channel plans. The channel plans are the
ones available for the current installation. At least one channel plan
has to be selected, either terrestrial or satellite. The wizard also gives
an option to select if during datalogger user wants to capture the list
of services (it slows down the process but gives more information) and
also if user wants a pause between channel plans (the process stops
until the user resume it). At the end user has the option to open the
new datalogger (by default, these last three options are enabled).
Once a new datalogger is created or selected an already existing one,
it shows the datalogger viewer screen and measurements of test
points can start.
If it is a new datalogger, in first place before starting the datalogger,
user must create a new test point (see next section).
To start the datalogger:
After creating a new datalogger file or selecting an existing one, the
user can start the datalogging process.
From the datalogger viewer screen, press the "Test point" key
from the menu select an existing test point using the "Go to ..." option
or "Create new ..." to create a new test point. If a new test point is
created, user has to give it a name.
Now datalogger is ready to start. Press the "Datalogger" key
select "Start".
7-102
: Previous to move to the previous screen or
: Next to move to the next
: Cancel to
2 2
and
and
June 2014