Promax HD RANGER 2 User Manual page 224

Settings
A6.3.2
User can adjust some parameters on the Signal Coverage analysis:
File name:
►
User can give a name to the file where data is saved. All measurement that
can be seen in the MEASUREMENT 1/3 screen (frequency, power/level, C/N,
PLP identifier, MER, CBER, LBER and LM) will be stored on the data file. Be
sure to change the file name when starting a new Signal coverage analysis. If
not, new data file will be saved on the last one.
Comment:
►
User can write some comments about the study.
Mode:
►
There are two options: Continuous or Manual. In continuous mode a
sample is taken automatically every sample time. In manual mode a sample is
taken every time that user presses the joystick.
Sample Time:
►
Time between acquisitions. Only when working in continuous mode. Minimum
time is 1 second.
Span time:
►
It is the width, in time, shown on screen for the X axis.
Save to:
►
There are two options: Internal or USB. For Internal option it saves the file
with all data in the internal memory of the equipment. For USB option it saves
the file with all data in a USB flashdrive connected to the micro-USB port of
the equipment.
June 2014
Figure A6.1.
6 6
73