Promax HD RANGER 2 User Manual page 131

Select the option DiSEqC mode.
Two new functions appear on the softkeys: Command
Select the command or program and press the joystick to send it to
the antenna. These commands or programs allow the user to control
an antenna (for more information about DiSEqC commands and
programs see
SatCR commands:
►
By means of function SatCR it is possible to control the devices of a TV satellite
installation that are compatible with the SatCR (Satellite Channel Router)
technology, which allows to concentrate downlink frequencies (slots) by an only
cable. By this way each user using a slot can tune and decode any signal present
in the satellite.
Connect the RF cable
signal of the equipment.
Press the Spectrum key
Press the Settings key
Select the polarization (horizontal/vertical) and the satellite band
(high/low).
If necessary, enable the Supply output and select the supply voltage
for the LNB.
In the option SatCR, select ON to enable it. It appears the
the top right corner.
Also in the SatCR option, select Configuration to access SatCR
parameters.
June 2014
. DiSEqC programs appear classified in categories or folders.
Annex 3).
(see Figure 6) to the RF connector for the input
to access the Spectrum analyser mode.
and select the satellite band.
3
and Software
icon at
10-123