Promax HD RANGER 2 User Manual page 175

Note: The LNB accept a very wide range of values for these voltages, usually
10-14.5V (for 13V) and 15.5-20V (for 18V).
In the
HD
RANGER
different menus (all the different ways indicate dare equivalent):
External units power supply
A3.3 DiSEqC
The use of DiSEqC
acknowledged by these ones, since it will determine the wiring diagram of the
different elements, as well as the way as they can be controlled. This information
must be provided by the device manufacturer.
Following appear the DiSEqC
and collective facilities.
A3.4 In the individual facilities
Tone-burst switcher (2 inputs – 1 output)
A3.4.1
It is the simpler DiSEqC
and allows to switch between two different Universal LNB:
24
, the band and the polarisation selection can be done from
2
Menu
Configuration
DiSEqC
around the world
TM
devices requires to know previously which commands are
TM
TM
switcher. This one uses the « SAT A/B » commands
TM
13 V, 18 V, 13 V+22kHz, 18 V+22kHz
Band: High / Low
Polarization: Vertical / Horizontal
Band: High / Low
Polarization: Vertical / Horizontal
devices more usually installed in the individual
Figure A3. 1.
Line
4 4
June 2014