Promax HD RANGER 2 User Manual page 112

Current channel plan, progress bar in the current channel plan, selected
test point.
Channel, frequency and Downlink.
The following describes the display of data acquired:
Selected installation; date and time.
Tab identifying the displayed test point.
Current datalogger name.
Selected band; battery level.
Tab identifying each test point.
Date and time when the datalogger was created. Number of channels
locked (PASS) or not locked (FAIL)
Data table with measurement data for each channel. In order from left to
right: Colour identifying if the channel has been locked (WHITE) or not
locked (RED) channel; signal type; power/level; Carrier/Noise (C/N) rate;
MER; Link Margin. Move the joystick up or down to navigate along the
measurement data. Press the joystick on a channel to display the signal
parameters.
7-104
Cancel
It cancels the datalogger.
Pause
It pauses datalogger until the user resumes by
pressing again.
Figure 69.
2 2
June 2014