V/A Output Connector - Promax HD RANGER 2 User Manual

10.1.2 Connecting a computer (host) to the
This connection allows the communication between the equipment and a
computer via an USB cable or using the program NetUpdate of PROMAX.
NetUpdate program can be downloaded for free from the PROMAX website.
Connect the equipment to your computer using the cable CC-041 (mini USB male
– USB male) supplied with the equipment.
For more information about the NetUpdate program, see the user's manual,
which is available on the PROMAX website.
10.2

V/A Output Connector

The V/A output connector allows connecting a video/audio analogue output
signal. This connection allows you to switch between the image from the
equipment to an auxiliary monitor by following these steps:
Connect the jack 4V cable to the video/audio output connector
( s ee figure
3
Connect the opposite end (RCA connector) to the auxiliary monitor
where video and audio of the equipment will be played.
Switch on the equipment and press the Settings key
In the Video & Audio Settings menu, enable Video output.
Then, the image on the equipment disappears and the auxiliary
monitor shows a message asking for confirmation to switch the image.
Press the joystick to accept and the image will appear on the auxiliary
monitor. If you do not press the joystick after ten seconds the image
will return to the equipment.
June 2014
5), ensuring that the plug is fully inserted.
HD 2 (device)
RANGER
2
for 1 second.
10-121