V/A Input Connector; Rf Connector - Promax HD RANGER 2 User Manual

10.3

V/A Input Connector

The V/A input connector allows connecting a video/audio analogue input signal.
This connection allows the user to view an image on the equipment screen
coming from an external source by following these steps:
Connect the supplied jack 4V cable to the video/audio input connector
(see Figure
Connect the opposite end (RCA connector) to the source of
video/audio.
Switch on the equipment and select the terrestrial and analogue
signal.
Select TV mode
From the menu, select "External". A message shows that the external
input has been selected.
After a few seconds, the input image will be displayed on screen.
With the option
image, between 4:3 and 16:9.
10.4

RF Connector

DiSEqC commands:
►
The RF connector allows controlling an antenna using DiSEqC commands. DiSEqC
(Digital Satellite Equipment Control) is a communication protocol between the
satellite receiver and the installation accessories of satellite (switches, LNBs,
etc.) proposed by Eutelsat, in order to standardize the diversity of switching
protocols (13 to 18 V, 22 kHz) and meet the needs of the installations for the
reception of digital TV.
Connect the RF cable
signal of the equipment.
Press the Spectrum key
Press the Settings key
From the Settings menu, select the polarization (horizontal/vertical)
and the satellite band (high/low).
If necessary, enable the Supply output and select the supply voltage
for the LNB.
10-122
5), ensuring that the plug is fully inserted.
and press
: Aspect, you can select the aspect ratio of the
(see Figure
to access the spectrum analyser mode.
and select the satellite band.
: Input.
6) to the RF connector for the input
3
June 2014