Joystick Operation - Promax HD RANGER 2 User Manual

Cursor
Red vertical line that indicates position during the channel or frequency
tuning.
When a digital signal is detected, there is a triple cursor that shows the
frequency for the signal locked and two vertical lines that shows the
bandwidth of the digital carrier.
In the case of a GENERIC signal, the bandwidth shown is the one selected
by the user on the "Signal Parameters" menu when pressing the
To change frequency/channel use the joystick (left, right) in FR mode
(tuning by frequency) or CH mode (tuning by channel).
Marker
It is a special cursor that can be placed on a given frequency to check the
power in this point.
This option can be enabled using the "Marker" option from the Advanced
menu (
mode.
The window Marker shows the following data:
Freq:
Level:
ΔF:
ΔL:
Centre frequency
Frequency at which the screen is centered. This frequency can be set
through the Tuning
4.4

Joystick Operation

In the SPECTRUM ANALYSER mode, the joystick can make different actions
depending on its active mode.
4-48
key). To change use the joystick (left, right) in MARKER (MK)
Frequency where is placed the marker.
Power level at the frequency where is placed the marker.
Difference of frequency between the marker and the main
cursor.
Difference of power level between the marker and the main
cursor.
menu. It also changes when moving the cursor.
8
key.
June 2014