Product Description Onboard Security I/O; Expansion Modules - Honeywell SEC-H-602 Manual

SEC-H-602 AND SEC-H-616 SECURITY CONTROLLER
PRODUCT DESCRIPTION
The Security Controller (models SEC-H-602 and SEC-H-
616) is an expandable, DIN rail-mountable, controller that
provides an embedded access control and security alarm
monitoring system. The controller hosts the WEBs-AX
Security Application, allowing password-authorized users
to access the system using a standard web browser.
Once authenticated, a user can configure and administer
the system. Apart from providing access control, features
include graphical real-time display of data, calendar and
scheduling functions, historical data logging, alarm
monitoring, and event handling. For more details on
features, see the data sheet for the WEBs-AX Security
SEC-H-602, SEC-H-616 Product Suite Automation
Solution Specification Datasheet. Form number 31-
00011.
One or two rechargeable, sealed-lead-acid backup
batteries allow system operation upon loss of primary
power, for some duration. In addition, the Security
Controller has a standard on-board NiMH battery to
ensure its configuration is always retained. See "About the
Backup Batteries" on page 24 for more information.
See the following sections for more details:
• "Onboard Security I/O"
• "Expansion Modules"
• "Option Cards"
• "WEBs-AX Security Enclosure"
Table 1. Security Controller (SEC-H-602 and SEC-H-616) type expansion modules.
Model
SEC-H-R2R/U Remote 2 Reader Module
DIN-mountable module that expands
the door reader capacity by 2, with
associated digital inputs and outputs.
SEC-H-RIO/U Remote I/O Module
DIN-mountable module that expands
capacity with 8 supervised inputs
and 8 relay outputs.
31-00012—03
Description
Onboard Security I/O
The Security Controller provides standard onboard
security I/O points, as follows:
• 2 card reader inputs (7-pin connectors, each can
power a 12V Wiegand-type reader)
• 6 supervised inputs (4 allocated for usage with
readers, 2 are general usage)
• 4 Form-C relay outputs (2 allocated for usage with
readers, 2 are general usage)
• 3 digital inputs (unsupervised, for predefined system
monitoring)
Additional security I/O points are achieved by adding
expansion modules. A fully expanded Security Controller
can support a total of 32 readers (using 15 SEC-H-R2R/U
expansion modules). Or, other combinations are possible
with fewer readers but more general usage I/O using
SEC-H-RIO/U expansion modules. See "Expansion
Modules" below.

Expansion Modules

Table 1 lists the currently available Security Controller
expansion modules. Note that the Security Controller
supports a maximum of 15 expansion modules, in any
combination of SEC-H-R2R/U and SEC-H-RIO/U needed.
NOTE: The SEC-H-602 requires a license expansion
pack to add any reader (SEC-H-R2R/U) mod-
ule, if both readers inputs on the Security
Controller are utilized. License expansion
packs are in 8-reader packs: part SEC-8-RDR.
Each SEC-H-R2R/U provides the following security points:
• 2 - Reader ports (each 7-pin, to power a 12V Wiegand-type
reader)
• 4 - Supervised inputs (2 per reader).
• 2 - Form-C relay outputs (1 per reader).
• 2 - Digital inputs for cabinet tamper and low battery detection.
Each SEC-H-RIO/U provides the following security points:
• 8 - Supervised four-state inputs (open, closed, short, and cut).
• 8 - Form-C relay outputs.
• 2 - Digital inputs for cabinet tamper and low battery detection.
2
Notes