How To Backup / Restore Configuration - Honeywell Touchpoint Plus Wireless Technical Handbook

MAN0984_Iss 2_09/19
3020M5001_2

8.7 How to Backup / Restore Configuration

You should always take a new back up of the Touchpoint Plus system configuration after changes are made and
Service or higher level access is required to back up the configuration
Note: The Touchpoint Plus Wireless system remains available during this procedure.
1) If it is safe to do so, unscrew the handle security screws and open the enclosure door.
2) Ensure that an empty 2 to 32 GB (FAT32) standard SD Card is inserted in the User interface module.
3) Login as Service.
4) Select the Menu > Configuration > Config Manager > Export.
5) Enter file name for the backed-up configuration and Touch Finish
6) Touch 'Export' if the file name is valid to start the configuration backup process. The backup may take
several minutes, and progress is shown on screen.
7) When backup is completed, remove the card and immediately fit a spare card to record event data.
8) Close the enclosure door and tighten the two handle security screws.
9) Return the system to normal operation.
10) Transfer the backup data to a dated folder on a PC or digital device for safekeeping. The Configuration
backup file is stored on the SD Card in 'SD card:\CFG\[filename].bin'
11) You can reuse the SD card once the data has been transferred to a PC or other device and deleted from
the card.
Note: You cannot import configuration files if the I/O module configuration has changed since the last backup.
To restore the configuration:
1) Insert the SD card with 'SD card:\CFG\[filename].bin' into the UI module SD Card slot
2) Login as an Administrator
3) Select the Menu > Configuration > Config Manager > Import. Select a file.
4) Once the action is confirmed, the configuration restoration process starts and a progress message is
displayed. The process may take several minutes depending on the system size.
Maintenance
CAUTION
confirmed to be OK.
82
Touchpoint Plus Wireless
Technical Handbook