Sierra Wireless MC8775 Reference Manual page 59

Table 4-2: Diagnostic command details (Continued)
Command
$QCPDPP=<cid>,
<auth_type>,<password>,
<username>
$QCPDPP?
Supporting Mini Cards:
•
All
$QCTER?
$QCTER=<rate>
$QCTER=?
Supporting Mini Cards:
•
All
Rev 2.9 Oct.08
Set / query PDP-IP connection authentication
parameters
This command sets authentication requirements (username, password)
for PDP-IP packet data calls for each supported profile.
Usage:
•
QCPDPP=<cid>,<auth_type>,<password>,<username> sets, for each
<cid> (profile), the type of authorization required when establishing a
connection.
•
QCPDPP? returns, for each profile, the username used for PAP
authentication—it does not display passwords.
Parameters:
<cid>
•
Supported profiles
•
Valid values: 1–16
<auth_type>
•
0 (none)—Username and password not required
•
1 (PAP)—Username and password accepted
•
2 (CHAP)—Username and password (secret) accepted
<password>
•
Supplied by network provider
•
Required for <auth_type> = 1 and 2
<username>
•
Supplied by network provider
•
Required for <auth_type> = 1 and 2
•
for <auth_type> = 2, the username can be any dummy value
Query / set TE-DCE baud rate
This command sets the baud rate at which DCE accepts commands over
the UART interface (the command does nothing when the USB interface is
used).
Usage:
•
QCTER? returns the current default TE-DCE baud rate.
•
QCTER=<rate> sets the default baud rate and stores it in NV RAM.
•
QCTER=? returns a list of supported baud rates.
Parameters:
<rate>
•
Use the QCTER=? command to list all supported baud rates.
Diagnostic Commands
Description
59