Introduction; Command Summary; Command Reference - Sierra Wireless MC8775 Reference Manual

2: AT Password Commands
•

Introduction

•

Command summary

•

Command reference

Table 2-1: AT command passwords
Command
!ENTERCND
!SETCND
Table 2-2: AT command password details
Command
!ENTERCND
=<"Key">
!ENTERCND?
Supporting Mini Cards:
•
All
Note: The assignment
operation ("=") is not
password-protected.
Rev 2.9 Oct.08
Introduction
The AT commands described in this document are password‐
protected. This chapter describes how to enter and change the
password.
Command summary
The table below lists the commands described in this chapter.
Enable access to password-protected commands
Set AT command password
Command reference
Enable access to password-protected commands
Before you can use any password-protected AT commands, you must enter the
password correctly using this command. The initial password is configured onto
the modem during manufacture. You can change the password using !SETCND.
If you do not know the password, contact your Account Manager at Sierra
Wireless.
Once the password has been entered correctly, the password-protected AT
commands are available until the modem is reset or powered off and on.
Usage:
• AT!ENTERCND=<"Key"> is used to unlock password-protected
commands.
• AT!ENTERCND? is password-protected. After entering the
password correctly using the assignment operation ("="), this
command can be used to display the password as a reminder.
Parameters:
<"Key"> (password):
• Password must be entered with quotation marks (for example,
AT!ENTERCND="ExamplePW").
• Password length = 4–10 characters (0–9, A–Z, upper or lower case)
Description
Description
2
Page
27
28
27