MC87xx Extended AT Command Reference
Table 3-2: Modem status, customization, and reset commands (Continued)
Command
!PCINFO?
Supporting Mini Cards:
•
All
Note: This command is not
password-protected.
48
Return power control status information
This command returns the modem's power control status in the format:
State: <state>
LPM force flags: W_DISABLE:0, User:0, Temp:0, Volt:0
W_DISABLE: <w_disable>
Poweroff mode: <pwroff>
User initiated LPM: <userlpm>
Note: In FW rev D0_0_4_1ap and earlier, "Poweroff enabled: <pwroff>"
replaces " Poweroff mode: <pwroff>"
Parameters:
<state> (The modem's power mode)
•
0 = Low Power Mode (LPM)
•
1 = Online
•
2 = Offline
•
3 = Power off (internal)
•
4 = Initialization (internal)
<LPM force flags> (Conditions that caused modem to enter LPM. 0=did
not cause, 1= caused):
•
W_DISABLE: W_DISABLE is asserted
•
USER: CnS / AT command was issued
•
TEMP: Temperature is outside operational limits
•
VOLT: Voltage is outside operational limits
<w_disable> (Current state of W_DISABLE)
•
0 = De-asserted
•
1 = Asserted
(FW rev D0_0_4_1ap and earlier)
<pwroff> (State of Power Off Enable modem feature—preset by device
manufacturer):
•
0 = Disabled
•
1 = Enabled
(Continued on next page)
Description
2130616