Sierra Wireless MC8775 Reference Manual page 33

Table 3-2: Modem status, customization, and reset commands (Continued)
Command
!CUSTOM?
!CUSTOM=?
!CUSTOM=
<customization>, <value>
Supporting Mini Cards:
•
All
Note: Some customizations
may not be available for older
modules (pre-MC8780/81) or
firmware revisions.
Rev 2.9 Oct.08
Modem Status, Customization, and Reset Commands
Set / query customization settings
This command identifies or sets several customization values.
Usage:
•
AT!CUSTOM? indicates customizations that are currently enabled
•
AT!CUSTOM=? returns a list of valid <customization> values
•
AT!CUSTOM=<customization>, <value> assigns <value> to a specific
<customization> setting
Parameters:
Note: Make sure that you include the quotation marks around the custom-
ization string when you use !CUSTOM=<customization>, <value>.
<customization> (String identifying customization setting. The default
value for all customizations is 0):
•
"AUTONETWORKMODE"—Indicate if UE should revert to Automatic
Network mode after 60 seconds of Manual Network mode
<value>: 0 = Remain in Manual; 1 = Revert to Automatic.
•
"CSDOFF"—Enable / disable ability of UE to initiate CS calls
<value>: 0 = Enable; 1 = Disable.
•
"CSVOICEREJECT"—Enable / disable ability to ignore incoming voice
call pages on 3G channels
<value>: 0 = Disable; 1 = Enable (Do not process voice pages).
•
"DISFDNPDPCHK"—Enable / disable FDN check for PS data calls
<value>:
0 = Allow FDN checking
1 = Disable FDN when checking PDP activation number
2 = Disable FDN when checking SMSC address
3 = Disable FDN when checking PDP activation number and when
checking SMSC address
•
"GPSENABLE"—Enable the Mobile Originated (MO) and/or Mobile-
Terminated (MT) GPS feature (and present the NMEA port to the host)
<value>: 0 = Disable; 1 = MT & MO enabled; 2 = MO enabled; 3 = MT
enabled.
•
"HPPLMNSCDIS"—Set HPLMN scan constraints
<value>: 0 = Include foreign MCC; 1 = Reject foreign MCC.
•
"HSDPATEST"—Enable / disable HSDPA test channel interface
<value>: 0 = Disable; 1 = Enable.
•
"HSICON"—Control HSPA icon behavior
<value>: 0 = Maintain HSPA icon if the bearer is revoked but remains
on the same cell; 1 = Revert to the UMTS icon if the bearer is revoked.
•
"ISVOICEN"—Enable / disable voice functionality
<value>: 0 = Disable voice-related CnS objects; 1 = Enable voice-
related CnS objects; 2 = Disable voice on both CnS and AT interfaces.
(Note: Voice functionality is available on the AT interface when
<value>=0 or 1.)
(Continued on next page)
Description
33