Sierra Wireless MC8775 Reference Manual page 18

MC87xx Extended AT Command Reference
Command
!SLEEP
!SWOCMODE
!UOOS
a. For some of these modules, a firmware upgrade may be required, as noted in the detailed command listing.
Command
!CMUX
!CMUXLPBK
!ERR
!GBAND
$QCPDPP
$QCTER
!RXDEN
!UMTSCHAN
Command
!DAFTMACT
!DAFTMDEACT
!DAGGAVGRSSI
18
Table 1-2: Modem status and reset commands (Continued)
Pg
53 Query / set Sleep Enable state
54 Set module operating mode
54 Query / set UMTS 'Out of Service' parameters
Diagnostic Commands
used to select frequency bands and diagnose problems.
Table 1-3: Diagnostic commands
Pg
55 Implement multiplexing mode
56 Configure ports into loopback mode / query
loopback state
57 Display diagnostic information
58 Read / set the current operating band
59 Set / query PDP-IP connection authentication
parameters
59 Query / set TE-DCE baud rate
60 Enable / disable WCDMA receive diversity
61 Query / set Priority UMTS Channel Selection state
Test Commands
to place the modem in particular modes of operation, test host
connectivity, and to configure the transmitters and receivers
for test measurements.
Table 1-4: Test commands
Pg
65 Put the modem into FTM mode
65 Put the modem from FTM mode into online mode
66 Return an averaged RSSI value in dBm (GSM
only)
Description
This chapter describes commands
Description
This chapter describes commands required
Description
Supporting
Mini Cards
All
MC8780 / 81
a
All
Supporting
Mini Cards
All
All
All
All
All
All
MC8780 / 81
MC8785V
MC8790 / 90V
All
Supporting
Mini Cards
All
All
All
2130616