Table 3-2: Modem status, customization, and reset commands (Continued)
Command
!SCROPROF?<pid>
!SCROPROF=<ro_flag>,
<pid>
Supporting Mini Cards:
•
All
!SLEEP?
!SLEEP=<state>
Supporting Mini Cards:
•
All
Rev 2.9 Oct.08
Modem Status, Customization, and Reset Commands
Set / query profile's read-only flag
This command is used to set / query the read-only flag of a profile.
Usage:
•
AT!SCROPROF?<pid> returns the flag value for the specified profile
(<pid>) in the format <pid>,<ro_flag>.
•
AT!SCROPROF=<ro_flag>,<pid> sets the read-only flag for the
specified profile.
Parameters:
<pid>: PDP context definition
•
1–16 — a valid profile ID that will be used as the default
<ro_flag>: Read Only flag
•
0 = Not write-protected
•
1 = Write-protected
Query / set Sleep Enable state
The modem supports a low-power sleep state that occurs when the
feature is enabled and specific operating conditions are met (for example,
there is no data traffic over USB, no OTA traffic, etc.).
This command is used to indicate the current state of the Sleep Enable
feature, and to set the state of the feature.
Usage:
•
AT!SLEEP? reports the current <state>.
•
AT!SLEEP=<state> sets the current state.
Parameters:
<state> (sleep state enabled / disabled):
•
0 = Disabled (Default) – The modem cannot enter the sleep state
under any conditions.
•
1 = Enabled – The modem can enter the sleep state when all condi-
tions are met.
Description
53