Sierra Wireless MC8775 Reference Manual page 35

Table 3-2: Modem status, customization, and reset commands (Continued)
Command
!CUSTOM
(Continued)
!DARPEN?
!DARPEN=?
!DARPEN=<enableFlag>
Supporting Mini Cards:
•
All
Note: Only the assignment
operation ("=") is password-
protected.
Rev 2.9 Oct.08
Modem Status, Customization, and Reset Commands
Set / query customization settings (Continued)
•
"PUKPRMPT"—Indicate if host will prompt for PUK code if maximum
number of PIN unlock retries is exceeded
<value>: 0 = Don't prompt; 1 = Prompt.
•
"RADIORESET"—Indicate if modem should reset when coming out of
Low Power Mode (AT+CFUN=1)
<value>: 0 = Reset; 1 = No reset.
•
"SCANPROF"—Enable / disable profile scan (try all profiles configured
on card until successful connection is found; the activated context
becomes the new default)
<value>: 0 = Disable; 1 = Enable.
•
"SKUID"—(Deprecated: Use
Assign a unique SKU ID to the modem
<value>: 0–255
•
"STARTLPM"—Enable / disable LPM (Low Power Mode) as the
startup mode for the user equipment
<value>: 0 = Disabled; 1 = Enabled (start UE in LPM).
•
"STKUIEN"—Enable / disable SIM toolkit UI
<value>: 0 = Disable; 1 = Enable for CnS interface (AT disabled);
2 = Enable for AT interface (CnS disabled).
•
"SWOCENABLE"—Enable / disable TRU-Install
cold- and soft-boot
<value>: 0 = Disable TRU-Install; 1 = TRU-Install enabled, enters
mode on cold- or soft-boot; 3 = TRU-Install enabled, enters mode only
on cold-boot.
<value> (Value being assigned to a specific <customization> setting):
•
1-digit numeric value. Valid range depends on the <customization>
type.
Enable / disable Downlink Advanced Receiver
Performance (DARP) for Single-Antenna Interference
Cancellation (SAIC)
This command enables or disables Downlink Advanced Receiver
Performance (DARP) for Single-Antenna Interference Cancellation
(SAIC).
Usage:
•
AT!DARPEN? indicates the current <enableFlag> setting—this shows
if SAIC-DARP is enabled or disabled. If the command returns ERROR,
SAIC-DARP is assumed to be enabled.
•
AT!DARPEN=? returns a list of valid <enableFlag> values.
•
AT!DARPEN=<enableFlag> enables or disables SAIC-DARP.
Parameters:
<enableFlag> (enable / disable SAIC-DARP mode):
•
0 = Disable SAIC-DARP
•
1 = Enable SAIC-DARP (Default) — This value is used for normal
operations.
Description
!PRIID
in place of this customization)
™
(SWoC) feature for
35