8: GPS Commands
•
Introduction
•
Command summary
•
Command reference
Table 8-1: GPS commands
Command
!GPSAUTOSTART
!GPSCLRASSIST
!GPSCOLDSTART
!GPSENABLE
!GPSEND
!GPSFIX
!GPSIPADDR
!GPSKEEPWARM
!GPSLOC
!GPSMTLRSETTINGS
!GPSNIQOSTIME
!GPSPORTID
!GPSPOSMODE
Rev 2.9 Oct.08
Introduction
This chapter describes commands used to access GPS function‐
ality in supporting modules.
Note: The modem must be in ONLINE mode to use these
commands—use AT!DAFTMDEACT to enter ONLINE mode.
Minimum firmware revision
The minimum required firmware revision for the commands
in this chapter is F1_2_0_0.
Command summary
The table below lists the commands described in this chapter.
Description
Configure GPS auto-start features
Clear specific GPS assistance data
Clear all GPS assistance data
(Deprecated) Enable GPS functionality and MTLR support
End an active session
Initiate a GPS position fix
Set / query IP address to use over TCP/IP
Set / clear / query Keep Warm functionality
Return the last known location of the modem
Set / query MT location request settings
Set / query GPS QoS timeout period for network-initialized
fixes
Set / query port ID to use over TCP/IP
Configure support for GPS positioning modes
8
Page
117
118
118
119
120
121
122
122
123
124
124
125
126
115