Install And Remove Transceiver Module; Safety Precautions For Module Installation And Removal; Install And Remove Sfp56, Sfp28, Sfp10, And Sfp Modules - Cisco NCS 540 Hardware Installation Manual

Install the Device

Install and Remove Transceiver Module

This section shows how to install and remove transceiver module.

Safety Precautions for Module Installation and Removal

Be sure to observe the following safety precautions when you work on the chassis.
Warning
Class 1 laser product. Statement 1008
Warning
Do not stare into the beam or view it directly with optical instruments. Statement 1011
Warning
Invisible laser radiations present. Statement 1016

Install and Remove SFP56, SFP28, SFP10, and SFP Modules

Before you remove or install an SFP56, SFP28, SFP10, and SFP module, read the installation information in
this section.
Warning
Class I (CDRH) and Class 1M (IEC) laser products. Statement 1055
Warning
Invisible laser radiation may be emitted from the end of the unterminated fiber cable or connector. Do not
view directly with optical instruments. Viewing the laser output with certain optical instruments (for example,
eye loupes, magnifiers, and microscopes) within a distance of 100 mm may pose an eye hazard. Statement
1056
Cisco Network Convergence System 540 Large Density Routers Hardware Installation Guide

Install and Remove Transceiver Module

45