GC-1F operators manual 4189340748 UK 1. Delimitation 1.1. Scope of Operator’s Manual........................3 1.1.1. GC-1F ............................3 2. General information 2.1. Warnings, legal information and safety....................4 2.1.1. Warnings and notes ........................4 2.1.2. Legal information and disclaimer ....................4 2.1.3. Safety issues ..........................4 2.1.4. Electrostatic discharge awareness ....................4 2.1.5.
GC-1F operators manual 4189340748 UK Delimitation 1. Delimitation 1.1 Scope of Operator’s Manual 1.1.1 GC-1F This document covers the following GC-1F versions: GC-1F SW version 1.2x.x GC-1F/2 SW version 2.0x.x or later DEIF A/S Page 3 of 9...
2.1.2 Legal information and disclaimer DEIF takes no responsibility for installation or operation of the engine set. If there is any doubt about how to install or operate the engine controlled by the unit, the company responsible for the installation or the opera- tion of the set must be contacted.
The general purpose is to give the operator important information to be used in the daily operation of the unit. Please make sure to read this manual before working with the GC-1F controller and the genset to be controlled. Failure to do this could result in damage to the equipment or human injury.
GC-1F operators manual 4189340748 UK Push-buttons, LEDs and display 3. Push-buttons, LEDs and display 3.1 Unit 3.1.1 Dimensions Front dimensions H x W 160 x 220 mm (6.30" x 8.66") Unit depth 54 mm (2.13") 3.1.2 Push-button functions The push-buttons on the unit have the following functions:...
GC-1F operators manual 4189340748 UK Push-buttons, LEDs and display 3.1.3 LED functions 1500V 1500V 1500V PROT VOLT HYSTERESIS LIMT DEL. HIST 1: Power OK indicator. 2: Flashing: active, non-acknowledged alarm(s) present. Steady: active, acknowledged alarm(s) present. 3: Additional alarm indication LEDs: Flashing: active, non-acknowledged alarm(s) where output A or B is configured to LED 1, 2, 3 or 4.
GC-1F operators manual 4189340748 UK Push-buttons, LEDs and display 3.1.4 Display functions The display indicates both readings and alarms. The examples below are with icons and English language. GC–1F Type, hardware and software version. HW x.xx SW x.xx Fuel level...
Page 9
The available parameters depend on the set options. Some parameters can only be changed using the PC utility software (USW) for GC-1F. The parameter list will automatically be aban- doned if no button is pressed during a 30 sec. period.